A new look to your hairs with a simple process. And through this we depict the dispensable hair frameworks. For long time hair wearers have bear the hairpiece tape. Peeling the support without end and adding the sticky tape takes a lot of time. As it would need precision in adding the tape in exact same position.

Our hair framework introduces completely prepared to-wear with a very solid tape implemented effectively. It would need to be applied for 30 days and after that it could be discarded.

You might be wondering how is it so easy.

We offer the complete hair system in acceptable amount. So you won’t need to worry about your pocket.

  • The expanded wear tape will be joined at the processing area.
  • The bond will be for 30 days
  • You will get 12 units for each year so as to not worry about any repairs.
  • And our treatment comes with no contracts attached to it so the procedure could be stopped at any point of time.

Soaking the hair system

To begin, draw a sink full of lukewarm water and gently dip the system in the water until the hair is thoroughly soaked. Then softly shake out any excess water from the hair.

After shaking the excess water out, lay the system down on a dry towel and fold it over top of the hairpiece, gently blotting the system until all the excess water is out.

Remove blue tape backing

Once the system has been thoroughly dampened and rinsed out, turn it over and peel off the blue tape adhesive backing from the underside. Then lightly spray a thin mist of Adjust A-Bond over the exposed tape.

Immediately after spraying the Adjust A-Bond on the tape surfaces, spray a liberal amount (don’t be shy) of the Adjust A-Bond onto your scalp — especially around the areas that the tape will touch your head.

Attaching the hair system

Immediately after spraying on the Adjust A-bond, place the disposable system onto your head. You will only have about 30 to 60 seconds to place and adjust the hair system before the adhesive begins to harden. After you are confident the hair is in the proper position, then begin to gently press the adhesive areas onto the surface of your head

Styling your hair

After the tape adhesive has bonded you can begin to direction style your hair. Begin by spraying a few pumps of our Spray Gel Mist or some other type of light styling gel to dampen the hair. Gently begin to brush through your hair in the direction that you would normally comb or style it.

For brush back styles, in order to loosen up the front, use the teeth of the brush or comb and gently press down on the front edge, dragging a little bit of hair forward to break up the front hairline.

Some more details about our procedure:

We guarantee an appearance that would be completely undetectable.

These systems are made from an ultra-fine lace material using the High Definition Hairline and bleached knots along with the scalloped fronts for a completely natural look.

12 brand new hair systems per year

We keep you in fresh new hair all year long by automatically delivering 2 systems every other month.

Low cost

The procedure will be low cost and quite affordable

Easy – No efforts process

As our super strong hairpiece tape is connected to your hair system at our factory all you need  to do is take it out of the box and apply it on your head.

Attaching your disposable hair system is quick and easy

Just follow some easy instructions below. However, to get the full 30 days out of your attachment it is absolutely essential to first properly clean and prepare your scalp!